Name / Surname:

E-mail:

Question:



 

10 common mistakes in installing plastic windows

10 common mistakes in installing plastic windows

The quality of work and a long service life of plastic windows largely depends on the installation. The main mistakes that are usually made when glazing.

  • Poor-quality preparatory work leads to the fact that the opening is poorly cleaned, the surface remains rough, and in such cases the polyurethane foam will not be able to completely fill all the gaps, which will further contribute to the accumulation of condensate.
  • The window did not fit. The profile of an unsuitable size does not allow full placement of the insulation (the gap between the window opening and the frame must be at least 4 cm). An incorrectly selected profile will help the windows to allow air and moisture to pass through.
  • Insufficient depth of the window opening. The close location of the installation of the window to the outer wall leads to cooling of the glass, and, as a result, the accumulation of condensate.
  • Inadequate cleaning of the window opening. When installing new window systems, dust remains in the opening, elements of the sealing tape. This makes it difficult for the foam to adhere well to the backing. Due to improper cleaning of the base - new windows can allow air to pass through, that is, blown out.
  • Poor deposition of the system. Do not leave a large gap between the slope and the window, the gap should not exceed 4 cm.
  • If the technology of wall insulation is violated, there is a risk of cold bridges. To avoid this, windows should be installed in a single-layer wall in the center, in a two-layer wall - in the lateral part of the insulation, and in a three-layer wall - in the heat-insulating plane.
  • Lack of a window sill. Such a defect leads to the ingress of moisture under the frame of the plastic window. The sill board should be narrower than the frame so that the sill can be installed.
  • The absence of an insulating tape leads to rapid wear of window systems. The insulator should be protected from the inside with a vapor barrier material, and from the outside - with a vapor-permeable material.
  • Blockage of the drain hole helps to reduce the tightness of plastic windows. • Fixation of fasteners without preliminary marking is a threat to the strength and rigidity of the structure. Fasteners must never resist thermal deformation.
  • Fixation of fasteners without preliminary marking is a threat to the strength and rigidity of the structure. Fasteners must never resist thermal deformation.
  • The absence of a casing box leads to squeezing of the frame by the opening, deformation of the plastic.





  • When Should You Order a Glass Shower Screen: Before or After Tiling?

    When Should You Order a Glass Shower Screen: Before or After Tiling?

    When renovating a bathroom, it is easy to overlook the right time to arrange the shower screen. Ordering the glass


    Facade Design Ideas for Modern Commercial Buildings

    Facade Design Ideas for Modern Commercial Buildings

    A commercial building’s facade is much more than an exterior finish. It shapes the first impression of a business,


    A Quiet Bedroom by the Road: Which Windows Actually Reduce Noise

    A Quiet Bedroom by the Road: Which Windows Actually Reduce Noise

    A bedroom facing a busy road can make rest feel almost impossible. Cars, motorcycles, buses, horns, and late-night


    When the Window Is Closed: 10 Hidden Causes of Drafts and Leaks

    When the Window Is Closed: 10 Hidden Causes of Drafts and Leaks

    A window can appear completely closed and still let in cold air, street noise, dust, or rainwater.


    Questions to Ask Your PVC Window Installer

    Questions to Ask Your PVC Window Installer

    A homeowner checklist that protects your budget, comfort, and warranty


    12345 ››